Hi, Can you please share the filter configuration with the term to accept icmp? Regards ------------------------------ Sheetanshu Shekhar ------------------------------

Good morning, Let me help to answer your questions, 1) set system radius-server 1.1.1.1 secret test ( This one is to use Radius for authentication towards access (system authentication)of the devices itself) so instead of using a local "username" you can use an authentication system like radius ...

Hi Dhikra, I assume your eBGP neighbour is connected to ge-0/0/0.0. Can you show the configuration of ge-0/0/0.0 ? The log message suggests the interface the router was using went down, or is no longer available in this VRF. Regards, Matt ------------------------------ Matthew Wright ...

Hi, The input filter name suggests a 20Mbps limit with a 2048k burst size. So yes it is likely the problem as it probably has a 20Mbps policer in that filter. Do you have another input filter for 50Mbps? If there is not already one created, I would suggest to create a new input filter with a suitable ...

Dears i need to know if i have MPC7E-Mrate 100G module in MX480 that have 2xSCBE2-MX modules, can i use the 4x100G interfaces with full capacity, because i have found in documentation that i can get 340 Gbps (redundant fabric configuration) only is that right??

Hello Colin, Thanks for your feedback. Now i have moved to next step, but got again some errors as mentioned below, thanks again for further assistance:- ------------------------------ [uni1389] ------------------------------

Thx for you reply Mr. Spuluka . I have the following device setup. Gateway -> srx300(15.1X49-D60.7) -> srx550(12.1X46-D40.2) -> device(wifi) -> device(wifi media bridge) -> standard switch stack(rvi completes here but my locale hates when I turn this off) The srx300 ...